Richell Inflatable Step Up Baby Bath (0-12months) Bear

Size: approx. 66 x 41 x 42.5 cm

Capacity: Fully filled 20L

　　　　 Baby Bath MAX line 9L

　　　　 Bath Chair MAX line 3L

Type: with built-in air pumps

Character: Bear

Recommended Age: 0 ~ 12 months

Recommended length of baby: 49 ~ 75 cm

• This baby bath and baby bath chair can be used for a long time as babies grow
• The bear cushion is removable
• 2 Built-in air pumps: Even mothers find it easy to inflate
• The inflatable baby bath is foldable, making it easy to store and carry. Also very useful when travelling!
• Baby-friendly soft bathtub
• Optimum water temperature: 37 - 40°C
• It is constructed with a horizontal air layer that is gentle on mothers' arms and a sturdy vertical air layer, making it both easy to use and strong
• The backrest has a good incline to keep the baby comfortably in the right position
• The stopper prevents a baby from slipping down
• Comes with a hook ring for drying after use
• The time to inflate: approx.1 minute
• Awards: No.1 Award in the baby bath category for 11 consecutive years – Tamahiyo Baby Goods Award 2023

1. Inflate the bath with air by using built-in air pumps

2. Put the water plug in firmly and then fill the bath with warm water
3. Adjust the temperature of the water to 37-40°C and fill up to the Bath MAX line for Baby Bath or Bath Chair MAX line for Bath Chair use
4. After use, drain the water through the plughole, wash and dry the bath at a well-ventilated place
5. Squeeze the air inlet between your fingers and press the bath gently to release the air

*Inflate to the extent that some wrinkles still remain on the outside of the bath. If too much air is put in, the heat of the hot water may cause the air to expand and damage the bath

*If you think the air is still not enough, open the air inlets (not the built-in air pumps) by squeezing it between your fingers and then inflate it with an air pump or your mouth. The air inlets are leak-proof.

*When using an air pump, be careful not to insert the tip more than 12 mm from the inlet. The air hole may be pushed open and deformed, preventing it from returning to its original position

*Do not fill with hot water above 50°C

*When attaching the bear cushion, inflate it with air first and place the latches in the holes at the back of the baby bath backrest and slide them sideways to secure. To remove them, slide them off in the opposite direction

*When folding the bath into a small piece, avoid the built-in air pumps

• Never leave the baby unattended during use
• Always support the baby's head with your hand during bathing to prevent drowning or water from getting into the ears
• Do not carry the bath with a baby in it
• Do not use this product on water but on a flat and stable surface
• When adding hot water, remove the child from the water first to avoid accidental burns
• Keep out of reach of children
• To prevent the formation of mould, wash and dry thoroughly after use
• Keep away from sharp objects

• Stop using the bath chair if the baby does not want to sit down, as there is a risk of injury from tipping over
• Do not allow babies to stand on it
• It is designed to be stabilised by the weight of the water. Please note that if there is not enough water or the baby is lightweight, the chair may fall over depending on the baby's movements

Note: Product images are for illustrative purposes only. Packaging may differ from the pictures due to product update